The two very important properties of a audio system is its volume and sound quality. Addition of an amplifier to the car stereo is one of the best way to bring an improvement in the sound quality and clarity. This also helps in getting a clearer signal. Quality is enhanced to the whole of the audio spectrum in addition to improvement in volume. This gives fuller sound to the lower tones and makes the higher ranging sounds more crisper. A professional can install this amplifier to the car stereo. Even an individual can connect an amplifier. But how to connect an original car stereo to an amp?

The works requires the following tools to proceed. It will require screw drivers of the Philips company, a drill, a panel tool, a kit which contains amplifier wirings , groomets and spacers made of rubber. It will also require the use of wires and harness adapter.

First of all the negative cable has to be disconnected from the battery. This cable gives the connection between the negative lead and the vehicle. The clamp of the cable is removed using a screw driver .It is left undisturbed until the process is completed.

Now the ring terminal of the amplifier, whose fuse has been removed, is connected to the positive lead of the battery. This ring amplifier is obtained from the kit. A screw driver may be used for this purpose. A hole is drilled in the firewall which is in the compartment of the car engine. This is used for the power supply of the amplifier. The wiring is protected using groomets. The amplifier is placed in the vehicle’s trunk. In case of trucks it is placed under the seat. Spacers are used in this case to provide ventilation.

The stereo is removed as per the manual instructions. It is kept in reach to the wiring. The wirings are removed and connected to the harness adapter with the help of plastic binders. The codes on the adapter will guide for the connections. The stereo is then connected to the adapter.

Using the hand, wiring groups are disconnected. The plastic binders are used to grab all the groups. The wiring harness adapter is connected to the groups. Clear indications will be given on how to connect them. Now a connection is established between the stereo of the car and the adapter. The signal cable and turn on lead is connected to the harness adapter. The panels are removed by using a trim panel. The wires are laid under the carpet. The power supply is run from the batteries to the amplifiers.

The power supply is connected. And then power on the lead in the amplifier. The desired speakers are connected to the amplifiers. The stereo in the dash board of the vehicle is replaced. The clamps are all re installed. Then the fuse is also installed.

Technology has made things easy and simple though it is complicated in its own working. The above article would have taught you how to connect an original car stereo to an amp. These works must be done with caution and accuracy. Thus take time to do this simple work with care.

Tags: Trucks

Popularity: 11% [?]