In this article we will discuss how to get good sound and power from stereo of car. For enhancing the lower tones of sound and adding bass ,installation of sub woofers is the best choice. This eliminates the need for purchasing an after market stereo. Let us learn How to Install a Sub woofer in a Factory Stereo.

Before we look at the steps for doing the job we should understand why speakers would not be sufficient to power the music. It is because speakers can improve the effect of sound of having only higher tones. The intricacies of lower notes , tones and bass can be taken care only with sub woofer.

There are many types of electrical crimping tool which comes in many ranges. It comes in rings, blades, butts, spades etc. An electrical crimping tool may get into usage in any kind of operations like hi fi, auto wiring, appliance repair and many other mechanical process. Wires are cut to the appropriate sizes required.

From the end of the wire the insulation is stripped off. The exposed ends are elongated a little bit than the metal portion so as to enhance a connection with the crimp connector. the wires are crushed with a finger to make it straight so that it goes into the connector properly and gets connected firmly. This will make the process of insertion easier.

Next step is the most important one. It is the installation of line out converter. It is also called as LOC. Locate the factory speakers. This is found inside the car trunk. Many wires are connected to the speakers . Now with cutting pliers disconnect one of these wires. However ensure that there is provision for reconnection of this wire. The line out converter is now fixed to the wiring . Next step is reconnection to that speaker (6×9) .

The subwoofer is then placed in the vehicle’s trunk. The sub is then grounded by connecting the corresponding wire to some bolt of the car. This can be done by lifting a part of the carpet for a bolt. The cable for signal, power supply and the lead for turn-on are connected.

The stereo is then replaced back in the dashboard of the car. Then the battery is reconnected by placing back the negative terminal cable on the negative terminal. The clamp can be tightened with the help of a screwdriver or a wrench.

We have learnt How to Install a Sub woofer in a Factory Stereo and now its time to try installing on our own

Tags: Trucks

Popularity: 10% [?]