One of the toughest job to be done is to wire an amplifier it takes a lot of time and patience to complete it. The job can be simplified if there is a manual or a set of instruction available about it. The part that makes other boring about this is that in this job there is a lot of chances for making a mistake. Because of a lot of wiring connection, the job will be tiresome. A wiring kit in hand can be very useful because it contains all the wires needed that too in the required size and also the color code for the wires are pre marked. This reduces the time taken to complete the whole job. The most important thing about the kit is that in many cases the cost of the kit is less when compared to the total cost of all components and also we don’t need to waste time searching every component. But how to install an amp kit?

This article lists all the things that are required for installing the amp kit and the instructions to install an amp kit. The things that are required are adjustable wrench, drill, screw driver, soldering gun and wire stripper. The battery is first disconnected before starting any wiring work. It is disconnected by detaching the negative terminal first followed by the positive terminal.

Identify any hole in your car’s heat shield. If you do not find any hole in the heat shield drill a hole. Make sure the hole drilled is larger so that the power wire can enter through it. The panel around the door frames are held by screws. Screws on the both sides of the car are loosened.

After this the wire is pulled near the back seat. Then from the back seat bring it to the trunk of the car by pulling it through the small holes in the seat. When the wire reaches the car’s trunk, it is connected to the amplifier’s positive terminal. Any excess wire is cut off. The wire is connected to the amplifier by using screws.

The trunk’s carpet is lifted to find the frame. A bolt is identified. It is loosened and the ring is soldered on the ground wire. The bolt is again tightened. The other side of the ground wire is connected to the negative terminal. The color coded ends of RCA wire are connected to the appropriate color outputs of the stereo receiver. RCA wire is run along the opposite side of the power wire. RCA is fed through the rear seats, trunk and then it is connected to the amplifier.

In the next step grounding of wire is done. A bolt is located and then tightened to secure the connection tight with the ring . This ring is covered with the ground wire. Electrical tapes are used for remote wire connections. These remote wires are finally connected to the receiver’s output. The speaker wires are then made to connect with the positive and negative terminals of the amplifiers and speakers.

Now the speakers are connected to the amplifier through wires and the wires are connected in the amplifier based on the terminals. Later all the screws are tightened for a secure system. The fuse is removed from its place and the power wires are connected. After this the fuse is replaced back in its position.

Thus we have learnt How to install an amp kit from this detailed article.

Tags: Auto

Popularity: 9% [?]